How To Avoid The Use Of Solar Garden Light

Precautions for the use of Solar Garden Light :

1. Avoid poor construction quality
Faults caused by construction quality account for a larger proportion. Main manifestations: First, the depth of the cable trench is not enough, and the construction of sand-covering bricks is not carried out according to the standard; the second is that the production and installation of the aisle pipe do not meet the requirements, and the two ends are not made according to the standard. The third is when laying the cable. Drag and walk on the ground; fourth, the embedded pipe of the foundation is not constructed according to the standard requirements, mainly because the embedded pipe is too thin, plus a certain degree of curvature, it is quite difficult to pass the cable, and there is a "dead bend" at the bottom of the foundation; It is because the thickness of the wire nose crimping and insulation wrapping is not enough, it will short-circuit between phases after a long time of operation.

2. Prohibited materials are not acceptable
Judging from the failures handled in recent years, low material quality is also a major factor. The main performance is: the wire contains less aluminum, the wire is relatively hard, and the insulation layer is thin. This situation has become more common in recent years.

3. The quality of supporting projects must be excellent
Lawn light cables are generally laid on the green belt. The construction quality of the sidewalk is poor, and the ground sinks, which causes the cable to be deformed by force, which leads to the cable armor. Especially in the northeast region, which is in the high cold zone, the winter comes, so that the cables and soil form a whole. Once the ground subsides, it will be strained at the bottom of the lawn lamp foundation, and in summer when there is a lot of rain, it will burn at the root of the foundation.

4. Reasonable design is very important
One aspect is overload operation. With the continuous development of urban construction, lawn lights continue to extend. When new lawn lights are built, they are often close to which lawn lamp is connected to which circuit. In addition, the advertising industry has developed rapidly in recent years, and the advertising load is also connected to the lawn accordingly. On the lamp, the load of the lawn lamp is too large, the cable is overheated, the wire nose is overheated, the insulation is reduced, and the grounding short circuit occurs; on the other hand, the pole design only considers the situation of the pole itself, ignoring the space of the cable head, After the cable heads are wrapped, most of them cannot even close the door. Sometimes the cable length is not enough and the joints do not meet the requirements, which is also the cause of the failure.